Touareg V10-5.0L DSL Turbo (BWF) (2006)
If no malfunctions are found in wires:
-
Replace Engine Control Module (ECM) (J623) --> [ Engine Control Modules, Replacing ] See: Computers and Control Systems/Testing and
Inspection/Component Tests and General Diagnostics/Engine Control Modules, Replacing.
Exhaust Gas Recirculation Valve 2 N213, Test Sequence
-
Disconnect 2-pin connector at Valve 2 for EGR (N213) (- B -)..
-
Measure resistance between terminals of valve.
Specified value: 14.0...20.0 ohms
‹› Resistance at room temperature is in lower specified range, resistance at operating temperature is in upper specified range.
If specified value is not obtained:
-
Replace Valve 2 for EGR (N213).
-
Erase DTC memory of Engine Control Module (ECM) --> [ Diagnostic Mode 04 - Erase DTC Memory ] .
-
Generate readiness code --> [ Readiness Code ] See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and
Readiness Codes.
If specified value is obtained:
-
Switch ignition on.