Touareg V6-3.2L (BMX) (2005)
/Page-1247002.png)
1. Camshaft Position (CMP) Sensor 1 (G40) intake camshaft
2. Camshaft Position (CMP) Sensor 2 (G163) exhaust camshaft
‹› Before disconnecting harness connectors, mark allocation to component.
Checking voltage supply
-
Connect multimeter between terminal 1 (B+) and 3 Ground (GND) for voltage measurement for the respective connector for hall sensor.
-
Switch ignition on.
Specified value: at least 4.5 V
-
Switch ignition off.
If there is no voltage:
-
Check wires to Engine Control Module (ECM) according to wiring diagram.
Checking wiring
-
Connect test box to control module wiring harness , connect test box for wiring test.
-
Check wires between test box and 3-pin connector for open circuit according to wiring diagram.
