Touareg V6-3.2L (BMX) (2005)
-
Coat sealing rings with clean engine oil.
-
Carefully insert camshaft adjustment valve into housing and press it perpendicular to valve axle in by hand until it stops.
-
Tighten the mounting bolts - arrows - to 3.8 Nm.
- 1 - camshaft adjustment valve 1 (N205) connector color: black.
- 2 - camshaft adjustment valve 1 (exhaust) (N318) connector color: brown.
-
Clean sealing surface on cover as well as on cylinder head.
-
If sealing rings in cover are to be replaced:
-
Lubricate oil channel seal O-ring --> [ (Item 15) O-ring ] See: Engine, Cooling and Exhaust/Engine/Cylinder Head Assembly/Valve Cover/Service
and Repair/Cylinder Head Cover, Assembly Overview and insert in cover.
-
Insert sealing ring --> [ (Item 12) Seal ] See: Engine, Cooling and Exhaust/Engine/Cylinder Head Assembly/Valve Cover/Service and
Repair/Cylinder Head Cover, Assembly Overview in cover.
-
Clean old sealing compound from the 3 mm holes in the cylinder head gasket - arrows -.
-
Fill 3 mm holes in cylinder head gasket with sealant (D 176 501 A1) and coat sealing surface on cover and sealing flange with sealant (D 176 501
A1).
‹› With the cylinder head installed only half of the holes in the cylinder head gasket are visible.
-
Install cover as quickly as possible.