Touareg V6-3.2L (BMX) (2005)
The previous data in the control module is erased and the new data is being transferred to the module from the flash CD.
Note:
Once "Update - Programming" function has been started, switching ignition OFF or disconnecting the diagnostic connector may completely destroy
the TCM.
Tip:
If, during the "Update - Programming"; a fault message is displayed:
-
Confirm that VAS 5051 or VAS 5052 diagnostic tool power supply is adequate and that ALL appliances with high electromagnetic radiation (i.e.
mobile phones are switched OFF.
-
The "Update - Programming" (flashing) process must then be started from the beginning using the "Repeat" button (arrow). DO NOT use the
"Cancel" button.
Note:
On NO occasion should the "Cancel" button be selected.
Once "Update - Programming" (flashing) is complete:
Similar screen appears.
Tip:
Old software level is still displayed at (arrows). New software level is not displayed until process is complete and fault memories have been erased.
-
Print this screen.