Touareg V6-3.2L (BMX) (2005)
‹› Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) (G130), bank 1, 4-pin harness connector 2-,
‹› Oxygen Sensor (O2S) 2 Behind Three Way Catalytic Converter (TWC) (G131), bank 2, 4-pin harness connector - 3 -.
Checking voltage supply and wiring to control module
-
Connect multimeter to terminals 1 +2 of connector to Engine Control Module (ECM) for voltage measurement.
-
Start engine, and let run at idle.
Specified value: at least 8.0 V
If specified value is obtained:
-
Switch ignition off.
-
Erase DTC memory of Engine Control Module (ECM) , Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code.
If specified value is not obtained:
-
Connect multimeter to terminal 1 of connector to Engine Control Module (ECM) + Ground (GND) for voltage measurement.