Touareg V6-3.2L (BMX) (2005)
/Page-1453006.png)
Similar screen appears.
"Update - Programming" (flashing), performing for TCM
After selecting "Update - Programming" function:
-
By selecting the ~ button, the 1CM programming procedure begins.
Similar screen appears.
The previous data in the control module is erased and the new data is being transferred to the module from the flash CD.
Note:
Once "Update - Programming" function has been started1 switching ignition OFF or disconnecting the diagnostic connector may completely destroy
the TCM.
Tip:
If, during the "Update - Programming"; a fault message is displayed:
-
Confirm that VAS 5051 or VAS 5052 diagnostic tool power supply is adequate and that ALL appliances with high electromagnetic radiation (i.e.
mobile phones are switched OFF.
-
The "Update - Programming" (flashing) process must then be started from the beginning using the "Repeat" button (arrow). DO NOT use the
"Cancel" button.
Note:
On NO occasion should the "Cancel" button be selected.
Once "Update - Programming" (flashing) is complete:
