Touareg V6-3.2L (BMX) (2005)
-
Attach print to vehicle Repair Order.
Once "Update - Programming" (flashing) is complete, the control module must be re-initialized.
-
Select the right arrow button.
^
The tester requests you to switch the ignition OFF.
-
Switch ignition OFF
Note:
^
Wait at least 20 seconds before switching the ignition back ON (failure to wait at least 20 seconds may damage the TCM).
After waiting 20 seconds:
-
Switch ignition ON.
After switching ignition ON, the TCM has been re-initialized, however, fault memories must now be erased.
Fault memories, erasing after "Update - Programming" (flashing)
Due to the CAN bus system, fault messages will be stored in various Control Modules during programming.
-
To erase ALL fault memories, confirm by selecting the right arrow button.
Tip:
This will take a few minutes, depending on how many control modules are accessed. Once fault memories have been erased: