Touareg V6-3.2L (BMX) (2005)
-
Remove D-pillar trim --> [ D-Pillar Trim ] See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/D-Pillar Trim.
-
Remove rear lock carrier cover --> [ Rear Lock Carrier Cover ] See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and
Repair/Rear Lock Carrier Cover
-
Remove luggage compartment floor --> [ Luggage Compartment Floor ] See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and
Repair/Luggage Compartment Floor.
-
Remove backrest:
‹› Left --> [ Left Seat Backrest ] See: Body and Frame/Seats/Service and Repair/Rear Seats
‹› Right --> [ Right Seat Backrest ] See: Body and Frame/Seats/Service and Repair/Rear Seats
-
Remove side wall trim --> [ Luggage Compartment Side Trim ] See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and
Repair/Luggage Compartment Side Trim.
-
Remove the two bolts - 1 - (9 Nm).
-
Disconnect the wiring harness - 3 - from the crash sensor - 2 -.
Installing
-
Perform the steps used for removal in reverse order.
-
Switch the ignition on.
CAUTION!
Make sure that no persons are in the vehicle.