Touareg V6-3.2L (BMX) (2005)
If specified values are not obtained:
-
Test oxygen sensor wires according to wiring diagram.
Checking oxygen sensor wires
-
Connect test box to control module wiring harness , connect test box for wiring test.
-
Disconnect 6-pin harness connector to the respective oxygen sensor:
‹› Heated Oxygen Sensor (HO2S) (G39), bank 1, 6-pin harness connector - 1 -,
‹› Heated Oxygen Sensor (HO2S) 2 (G108), bank 2, 6-pin harness connector - 4 -.
-
Check wires between test box and 6-pin connector to Engine Control Module (ECM) for open circuit according to wiring diagram.
Wire resistance: max. 1.5 ohms