Touareg V6-3.2L (BMX) (2005)
Specified value: infinite ohms
If no malfunctions are found in wires:
-
Check adjustment of Multi-Function Transmission Range (TR) Switch (F125) , Multi-Function Transmission Range (TR) Switch, removing and
installing, adjusting.
-
Check adjustment of selector lever cable , Selector lever cable, adjusting.
-
Erase DTC memory of Transmission Control Module (TCM) , Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code.
If no malfunctions are detected in wires and adjustments of selector lever cable and Multi-Function Transmission Range (TR) Switch are OK:
-
Replace Multi-Function Transmission Range (TR) Switch (F125) , Multi-Function Transmission Range (TR) Switch, removing and installing,
adjusting.
Final Procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to --> [ Diagnostic Mode 03 - Read DTC Memory ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09.
2. If necessary, erase the DTC memory. Refer to --> [ Diagnostic Mode 04 - Erase DTC Memory ] See: Powertrain Management/Computers and
Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09.
3. If the DTC memory was erased, generate readiness code. Refer to --> [ Readiness Code ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.