Touareg V6-3.2L (BMX) (2005)
/Page-2043001.png)
Alternator Pulley: Service and Repair
Generator (GEN) Ribbed Belt Pulley - 6-cyl. Engine, Removing And Installing
Special tools, testers and auxiliary items required
-
Torque wrench V.A.G 1332/ (or 40 - 200 Nm equivalent)
-
Multi-tooth adapter VAS 3400
Removing:
-
Clamp generator on bracket points in bench vise.
-
Remove protective cap from freewheel pulley.
NOTE: Thread on generator shaft is left-handed. Turn clockwise to loosen. Turn counter-clockwise to tighten.
-
Insert Multi-tooth adapter 3400 -1 - with box-end wrench into freewheel pulley - 2 -. Then, insert a Multi-tooth socket insert M 10 - 3 - into
generator shaft.
-
Loosen threaded connection by rotating clockwise, while counterholding with box-end wrench.
-
Hold the freewheel pulley firmly by hand and rotate it on the generator drive shaft until the freewheel pulley can be removed.
Installing:
Install in reverse order of removal, noting the following:
