Touareg V6-3.2L (BMX) (2005)
‹› Clamp fastener - 1 - must be above bracket - 2 -. From this it follows that the clamp is tightened from below.
‹› Clamp must directly make contact at bracket - 2 - - arrow -.
Stabilizer bar mount clamp installation position on vehicles with active body control
‹› The bolt - 1 - must be at the top.
Subframe, Stabilizer Bar and Lower Control Arm Assembly Overview
Subframe, Stabilizer Bar and Lower Control Arm Assembly Overview
‹› Welding and straightening work on supporting or wheel carrying components of suspension is not permitted.
‹› Always replace self locking nuts.
‹› Always replace corroded bolts/nuts.
‹› If components with bonded rubber bushings were replaced or bolts/nuts on these components were loosened, corresponding wheel bearing must
be lifted into curb weight position. Refer to --> [ Lifting Wheel Bearing to Curb Weight Position ] See: Alignment/Service and Repair/Front
Suspension (AWD).