volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Procedures|Page 12635 > < Procedures|Page 12633
Page 13
background image

‹› Observe important notes about removal and installation, refer to --> [ If residual pressure retaining valve sticks, the vehicle must be on a hoist

and the wheels must rotate freely in order to replace the valve. ] See: Service and Repair/Removal and Replacement/Rear Suspension/Residual
Pressure Retaining Valve.

‹› Removing and installing, refer to --> [ Residual Pressure Retaining Valve ] See: Service and Repair/Removal and Replacement/Rear

Suspension/Residual Pressure Retaining Valve. 

7

Air spring

‹› Follow repair notes for servicing air spring dampers, refer to --> [ Air Spring Damper, Repair Information ] See: Procedures/Rear

Suspension/Air Spring Damper, Repair Information.

When the vehicle has been driven 200,000 km, if there is damage to  an air spring, it is recommended that the opposite air spring is also replaced. 

8

Buffer stop

9

Nut, 7 Nm

10

Protective cap

11

Shock absorber

‹› Follow repair notes for servicing air spring dampers, refer to --> [ Air Spring Damper, Repair Information ] See: Procedures/Rear

Suspension/Air Spring Damper, Repair Information.

12

Seal

‹› Always replace.

‹› Grease with  (N 052 150 00).

13

Protective sleeve

14

Clamp

Air Spring Damper Components

Air Spring Damper Components

‹› The --> [ (Item 2) Cover ] , --> [ (Item 3) Outer guide ] , --> [ (Item 4) Boot ] , and --> [ (Item 5) Rolling piston ]  are components of  the air

spring damper. They are installed together and cannot be disassembled. 

Procedures|Page 12635 > < Procedures|Page 12633