volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 7874 > < Diagram Information and Instructions|Page 7872
Page 2
background image

‹› Resistance value is valid at approx. 20° C. At higher temperatures,  resistance value increases.

If one of the specified values is not obtained:

-

Replace respective solenoid valve.

-

Erase DTC memory of Transmission Control Module (TCM) , Diagnostic  mode 4: Reset/erase diagnostic data.

-

Generate readiness code.

If specified values are obtained:

-

Check wires to Transmission Control Module (TCM) according to wiring  diagram.

Checking wiring

-

Connect test box to control module wiring harness , connect test  box for wiring test.

-

Check wires between test box and 14-pin connector to Transmission  Control Module (TCM) for open circuit according to wiring diagram.

Wire resistance: max. 1.5 ohms

Diagram Information and Instructions|Page 7874 > < Diagram Information and Instructions|Page 7872