Touareg V6-3.2L (BMX) (2005)
/Page-1543003.png)
Vehicle requirements
^
Battery MUST have minimum no-load charge of 12.5V (failure to maintain voltage during update process can lead to ECM / TCM failure) (you must
use an approved battery charger to maintain battery voltage).
^
VAS 5051: connected to vehicle and to 110V AC Power supply at all times during procedure.
^
VAS 5052: connected to vehicle with battery voltage requirements met.
^
Any appliances with high electromagnetic radiation (i.e. mobile phones) switched OFF.
^
No Stored DTC's, erase any stored DTCs.
Note:
Non-observance of the following points may lead to ECM / TCM failure! VAS 5051 or 5052 must always be connected to the approved power
supply at the approved voltages. Under no circumstances should the power supply be interrupted or the diagnostic connector unplugged during
the flash procedure.Any appliances with high electromagnetic radiation (i.e. mobile phones) must be switched OFF "Update - Programming"
(flashing) procedure, checking for update match
-
Switch ignition ON.
-
Switch VAS 5051/5052 ON and insert flash CD into CD drive as soon as start screen appears.
Note:
You must return to the start screen before starting a new (flashing) session, otherwise the flashing CD will not be recognized by the tester.
-
Select "Vehicle Self Diagnosis" mode.
Similar screen appears. Using the scroll bar to the right of the screen:
