Touareg V6-3.2L (BMX) (2005)
Wiper Motor: Service and Repair
Windshield Wiper Motor, Installing In Wiper Frame
Windshield Wiper System
Windshield Wiper Motor, Installing in Wiper Frame
‹› If a linkage with part number 7L0.955.601.B/ 602.B or higher is installed on a Touareg through MY 2007, the plenum chamber cover must be cut
before installing --> [ Wiper Frame with Linkage, through 22.07 ]. See: Service and Repair/Removal and Replacement/Windshield Wiper
System/Wiper Frame With Linkage, Through 22.07
-
Insert Windshield Wiper Motor (V) into wiper frame and secure it with mounting bolts - arrows -.
-
Tighten the threaded connections to the specification given in the assembly overview --> [ Windshield Wiper System Assembly Overview ] See:
Service and Repair/Removal and Replacement/Windshield Wiper System Assembly Overview.
-
Let Windshield Wiper Motor (V) run to rest position, to do so, connect connector to Windshield Wiper Motor (V) and operate windshield wiper
switch briefly to do so.
‹› Hood (Front Hood Switch (F266)) must be closed to activate windshield wiper functions.
-
Place crank - 2 - onto shaft of Windshield Wiper Motor (V), the distance - A - between crank - 2 - and pin - 3 - must be 0.16 in.
-
Thread on crank - 2 - with hex nut - 1 -.
-
Tighten the hex nut - 1 - to the specification given in the assembly overview --> [ Windshield Wiper System Assembly Overview ] See: Service
and Repair/Removal and Replacement/Windshield Wiper System Assembly Overview.
CAUTION!