Touareg V8-4.2L (AXQ) (2006)
Parking Brake Shoe: Adjustments
Park Brake Adjusting
‹› Adjustment must only be performed on both adjustment devices for rear wheels! Adjustment must never be performed at park brake pedal or
transfer module on center console!
‹› Observe correct routing and guiding of park brake cables!
‹› If the brake shoes were replaced, adjust air gap to the 6th teeth. Then run in brake shoes by braking vehicle in a single maneuver from a speed of
approximately 50 km/h. Rear wheels must not lock up when doing so.
-
Park brake pedal in released position.
-
Remove rear wheels.
Brake discs must move freely. If necessary, press brake pads slightly back or move rear brake cables slightly back and forth.
-
Remove bolt - arrow - for adjustment nut of park brake.
Adjusting Brake Shoes on Both Wheels
-
Push screwdriver through hole in brake disc and turn adjustment nut - A - against resistance of pull spring - B - until brake disc can no longer be
turned.
-
Then loosen adjustment nut 6 teeth. Brake discs must move freely again.
-
Free play of park brake pedal must be checked again.