Touareg V8-4.2L (AXQ) (2006)
‹› Heated Oxygen Sensor (HO2S) (G39), bank 1, 6-pin harness connector - 2 -,
‹› Heated Oxygen Sensor (HO2S) 2 (G108), bank 2, 6-pin harness connector - 4 -.
‹› Bank 1 = Cylinder bank 1, in direction of travel, right.
‹› Bank 2 = Cylinder bank 2, in direction of travel, left.
Checking voltage supply and wiring to control module
-
Connect multimeter to terminals 3 + 4 of connector to Engine Control Module (ECM) for voltage measurement.
-
Start engine, and let run at idle.
Specified value: at least 7.0 V
If specified value is obtained:
-
Switch ignition off.
-
Erase DTC memory of Engine Control Module (ECM) , Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code.
If specified value is not obtained:
-
Connect multimeter to terminal 3 of connector to Engine Control Module (ECM) + Ground (GND) for voltage measurement.