Touareg V8-4.2L (AXQ) (2006)
/Page-1273006.png)
If, during the "Update - Programming", a fault message is displayed:
^
Confirm that VAS 5051B, or VAS 5052 diagnostic tool power supply is adequate and that ALL appliances with high electromagnetic radiation (i.e.
mobile phones) are switched OFF.
^
The "Update - Programming" (flashing) process must then be started from the beginning using the "Repeat" button (arrow). DO NOT use the
"Quote" button.
Once "Update - Programming" (flashing) is complete:
^
Similar screen appears.
Tip:
Old software level is still displayed at (arrows). New software level is not displayed until process is complete and fault memories have been erased.
^
Print this screen.
^
Attach print to vehicle Repair Order.
Once "Update - Programming" (flashing) is complete, the Differential Control Module must be re-initialized.
^
Select the forward arrow button.
^
The tester requests you to switch the ignition OFF.
^
Switch ignition OFF.
Note
After switching ignition ON, the Differential Control Module has been re-initialized, however, fault memories must now be erased.
