Touareg V8-4.2L (BAR) (2007)
Parking Assist Distance Sensor: Service and Repair
Front Parking Aid Sensors
Parking Aid System
Front Parking Aid Sensors
6 sensors are located in front bumper cover.
‹› Removal and installation of sensors for parking assistance, front, is performed in the same way for all sensors and is only described for one
sensor.
Special tools, testers and auxiliary items required
‹› Release tool (T10345)
Removing
-
Switch off ignition, switch off all electrical consumers and remove ignition key.
CAUTION!
The sequence of removal of the sensors must be strictly followed.
Otherwise, the sensor may be damaged. If the force exerted on a sensor is too large, hair cracks can develop which in turn can lead to
sensor failure.
First remove the sensors from the brackets with the removal tool and then disconnect the sensor connectors.
-
Remove front bumper cover Removal and Installation.
-
Disengage retaining tabs - arrows - with Release Tool (T10345) and remove sensor with connector connected from bumper cover.
‹› Make sure that the sensor seal does not remain in bumper cover.
-
Disconnect electrical connection - arrow -.