Touareg V8-4.2L (BAR) (2007)
‹› To guarantee that the driveshaft engages correctly in oil pump, insert driveshaft only into oil pump, do not install together with spur gear unit.
-
Cut tube nozzle at front marking (nozzle dia. approximately 1.5 mm).
-
Apply sealant beads - arrows - on clean sealing surfaces of front bearing cap as shown in illustration.
‹› Thickness of sealant beads: 2.0 mm.
-
Position O-ring - 1 - and secure it with some grease.
‹› The bearing cap must be installed within 5 minutes after application of sealant.