Touareg V8-4.2L (BAR) (2007)
If the valve seal removal tool (3364) cannot be used on some valve stem seals due to restricted clearance, proceed as follows:
-
Using a drift, drive out roll pin - arrow - at puller with a drift and remove the impact puller attachment.
-
Place lower part of puller on valve stem seal.
-
Secure puller with a drift or cotter pin driver - 1 -, as shown in illustration.
-
Place lever on puller and pull off valve stem seal - arrow -.
‹› A plastic sleeve - A - is supplied with the new valve shaft seals.