volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Fuel Supply|Page 7187 > < Fuel Supply|Page 7185
Page 7
background image

If no malfunction can be found:

-

Replace sensor flange with pressure relief valve --> [ (Item 15) Flange ] See: Fuel Tank/Service and Repair/Removal and Replacement/Fuel Tank
and Attachments Assembly Overview. 

-

Repeat the test.

If fuel pressure is not obtained again:

-

FP faulty, replace fuel delivery unit. Refer to --> [ Fuel Delivery Unit and Fuel Level Sensor ] See: Service and Repair/Fuel Delivery Unit and
Fuel Level Sensor.

Residual Pressure, Checking

Test Conditions

‹› The pressure gauge (VAG 1318) remains connected.  Refer to --> [ Fuel Pressure, Checking ].

‹› Fuel pressure of approximately 5.6 bar is displayed on pressure  tester (VAG 1318), checking. Refer to --> [ Fuel Pressure, Checking ].

‹› Remote control (VAG 1348/3A) is connected. 

Test Sequence

-

Watch pressure drop on gauge. After 10 minutes the pressure must  not drop below a 4.0 bar decrease.

If the pressure drops below 4.0 bar:

-

Operate the remote control (VAG 1348/3A) and observe display of pressure tester (VAG 1318) while doing this.

Fuel pressure must increase up to a maximum pressure of 6 bar.

-

Release control button for the remote control (VAG 1348/3A) and immediately close the shut off valve on the pressure  tester. Lever then points
perpendicular to flow direction - arrow -. 

‹› When releasing control button for the remote control (VAG 1348/3A), fuel pressure decreases to approximately 5.6  bar.

If the Pressure Drops Below 4.0 Bar Again

(Leak on fuel tank side)

-

Check connections to fuel tank for leaks.

If no malfunction can be found:

-

Check fuel filter for leaks.

Fuel Supply|Page 7187 > < Fuel Supply|Page 7185