Touareg V8-4.2L (BAR) (2007)
/Page-2750011.png)
-
Check boot for wear (slits, cracks) and check sealing surfaces of boot for dirt.
-
Install bellows and clamp.
‹› Only use original clamps.
-
Tighten clamp using locking pliers (VAS 6199) as far as shown in illustration.
Further installation is in the reverse sequence to removal.
-
After installation, a vehicle alignment must be performed. Refer to --> [ Wheel Alignment ] See: Alignment/Service and Repair/Wheel Alignment.
-
Perform basic setting for steering angle sensor (G85).
Tightening Specifications
