Touareg V8-4.2L (BAR) (2007)
-
Install tools and bonded rubber bushings onto wheel bearing housing, as shown in illustration.
1. Nut (T10230/2)
2. Press piece (T10230/13)
3. Thrust pad (T10230/6)
4. Bonded rubber bushing
5. Press piece (T10230/8)
6. Tube (T10230/3)
7. Thrust plate (T10230/7)
8. Hydraulic press (VAS 6178) with pressure head (T10205/13)
-
Press in bonded rubber bushing until stop.
By doing this, core of bonded rubber bushing is pressed in by thrust piece (T10230/6) - arrow - more than is required. However, this is necessary so
that bonded rubber bushing lip makes contact with control arm on outside. After loosening hydraulic cylinder (VAS 6178), bonded rubber bushing
core settles into correct position.
-
Remove wood block from between wheel bearing housing and lower control arm.
-
Press wheel bearing housing in - direction of arrow -.