Touareg V8-4.2L (BAR) (2007)
-
Take note of this value. After the seal is replaced, friction torque must be restored to this value.
Use friction meter (VAS 6222).
-
Remove nut for driveshaft flange.
A 2 M10 x 25 bolts
When loosening the nut of the driveshaft flange, counter hold using counter holder (3435) (2nd technician).
-
Mark installation position of driveshaft flange - arrow A - relative to drive pinion - arrow B -.
-
Remove the driveshaft flange. Use a slide hammer (VW 771) if it is difficult.
-
Pull out sealing ring.