Touareg V8-4.2L (BHX) (2004)
Alarm Module: Service and Repair
Access/Start Authorization Control Module
Access/Start Authorization Control Module
‹› Perform the following procedure if the control module will be replaced:
‹› with immobilizer through 11.06 --> [ Access/Start Authorization Control Module, Replacing ] See: Testing and Inspection/Component Tests and
General Diagnostics/Immobilizer, through 11.06
‹› with immobilizer from 12.06 --> [ New Access/Start Authorization Control Module ] See: Testing and Inspection/Component Tests and General
Diagnostics/Immobilizer, from 12.06 or --> [ Used Access/Start Authorization Control Module ] See: Testing and Inspection/Component Tests
and General Diagnostics/Immobilizer, from 12.06
Removing
-
Switch off ignition, switch off all electrical consumers and remove ignition key.
-
Remove the driver lower storage compartment
-
Remove the bolt - arrow - and the ventilation duct - 1 -.
-
Press both retaining tabs - 2 - apart and pivot the access/start authorization control module - 1 - out of the bracket in the - direction of the arrow
-.
-
Remove the access/start authorization control module - 1 - downward from the bracket. Be careful of the connected wires.