Touareg V8-4.2L (BHX) (2004)
‹› The laser point is aligned on the center of the Volkswagen logo
2
Wheel center sensor (VAS 6350/1)
3
Right-side angle bracket for mounting measuring unit for distance measurement
4
Calibration Device (VAS 6350/4)
‹› Distance between the angled brackets on the calibration device (--> [ (Item 3) Right-side angle bracket for mounting measuring unit for
distance
measurement ] or --> [ (Item 9) Left-side angle bracket for mounting measuring unit for distance
measurement ]) and the paddles on the rear wheel center wheel mounts: 1.2 m - 1.7 m - dimension A -
5
Plastic foot
‹› Total of three on the bottom side of the calibration device
‹› adjustable in order to adjust the horizontal position of the calibration device
6
Spacing laser (VAS 6350/2)
‹› Notes on operation, --> operating instructions
7
Line Laser (VAS 6350/3)
‹› Switching on and off --> operating instructions
8
Level on the calibration device
‹› to check the horizontal position of the calibration device
9
Left-side angle bracket for mounting measuring unit for distance measurement
10
Wheel center sensor (VAS 6350/1)
Preliminary Work for Calibration
Preparations must be made before the calibration procedure can be performed with the vehicle diagnosis, testing and information system.
Requirements:
‹› Place vehicle on a solid, level surface.
‹› Engage the parking brake - the vehicle must not move during calibration.
‹› On vehicles with air suspension, set the suspension height to " Auto" while the engine is running. Then bring the suspension into vehicle lift mode.
Vehicle Lift Mode (level control system is switched off).
‹› No persons may be in the vehicle interior during the calibration.
‹› Do not open and close the vehicle doors during calibration.
‹› Make sure the vehicle is at curb weight *.
*
Curb weight means: the weight of the vehicle when it is ready for driving (full fuel tank, spare wheel, vehicle tool kit, vehicle jack).
Special tools, testers and auxiliary items required
‹› Vehicle Diagnosis, Testing and Information System
‹› Calibration Device (VAS 6350)
Connect Vehicle Diagnosis, Testing and Information System.
-
Check which hole circle the rims have.