Touareg V8-4.2L (BHX) (2004)
/Page-3403002.png)
-
Locate screws attaching plastic locator channel to door panel -A- and -B-.
-
Remove three center screws -A- from plastic locator channel, located on back side of door panel.
-
Loosen screws -B- at each side of center screws -A-.
-
Flip Panel over.
-
Insert Special Tool No: JC4350 (0.5 mm feeler gauge) between panel and plastic locator channel at area previously marked with tape (near
arrows).
This creates a minimum of 0.5 mm gap between plastic locator and the door panel vinyl.
With Special tool No: JC4350 (0.5 mm feeler gauge) held in place:
-
Install center screw -A- in a new location on plastic channel.
