Touareg V8-4.2L (BHX) (2004)
-
Moisten new O-ring with coolant and install.
-
First, fasten coolant thermostat housing bolts by hand, and then tighten them to 10 Nm.
If coolant pump must be replaced:
-
Remove nuts - 1 - for toothed belt cover.
-
Remove all bolts for coolant pump - arrows -.
Installation is in reverse order of removal, note the following:
-
Insert coolant pump with gasket.
-
Fasten all bolts by hand and then tighten. Torque specification: 14 Nm
-
Install toothed belt --> [ Toothed Belt, Removing, Installing and Tensioning ] See: Timing Components/Timing Belt/Service and Repair/Removal
and Replacement/Toothed Belt, Removing, Installing and Tensioning
-
Install ribbed belt --> [ Ribbed Belt ] See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Ribbed Belt
-
Fill with coolant --> [ Cooling System, Draining and Filling ] See: Cooling System/Service and Repair/Procedures.