volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Defroster Door|Page 12667 > < Defroster Door|Page 12665
Page 10
background image

Installation is carried out in the reverse order, when doing this  note the following:

-

When installing, make sure control motor drivers - A - are  pushed into retainers - B -.

-

Initiate the basic setting function with the Vehicle Diagnosis,  Testing And Information System (VAS 5051B).

Defroster Door and Front Air Distribution, Manual A/C System

Door Motors

Defroster Door and Front Air Distribution, Manual A/C System

Removing 

‹› The Defroster Door Motor (V107) and the Front Air Distribution Motor (V145) are located on  the A/C unit on the left retaining plate.

-

Initiate control motor Basic Setting function with Diagnostic  Operation System (VAS 5051B). Refer to --> [ Climatronic A/C System with
Automatic Control, Checking and Adjusting ] See: Testing and Inspection/Component Tests and General Diagnostics/Climatronic A/C System
with Automatic Control, Checking and Adjusting.

-

When SF appears on the left of the Climatronic operating display,  switch ignition off.

‹› Control motors can only be re-installed in the service position after  removal.

-

Remove lower dash panel trim.

-

Removing and installing entry and start authorization control unit.

-

Removing relay carrier and on board supply control unit.

-

Remove the retaining plate screws - 3 -.

Defroster Door|Page 12667 > < Defroster Door|Page 12665