Touareg V8-4.2L (BHX) (2004)
Removing
-
Remove the driver side trim.
-
Disconnect connector from brake light switch.
The brake light switch must only be removed when plunger is pressed (brake pedal not operated), otherwise the retainer on the brake light switch will
be damaged.
-
Remove brake light switch by turning 45° to the left.
Installing, Adjusting and Locking
Before installing the brake light switch, grease the clear rounded end on the plunger head with polycarbamide grease (G 052 142 A2).
‹› When installing brake light switch, brake pedal must always remain in rest position. The brake pedal may only be touched with the brake light
switch plunger head during the entire assembly procedure.
‹› The assembly openings are arranged vertically in the illustration. The are arranged horizontally from Vehicle Identification Number (VIN)
7L-6-053 601.
-
Guide the brake light switch through assembly opening - arrow 1 - and press it against the pedal with the plunger head. Then turn the brake light
switch 45° to the right - arrow 2 -, until it noticeably engages.