Touareg V8-4.2L (BHX) (2004)
Camshaft Position Sensor: Procedures
Ignition Components, Removing And Installing
NOTE:
-
Cylinder bank 1 is located on right side in direction of travel.
-
Cylinder bank 2 is located on left side in direction of travel.
-
Components marked with * are tested via On Board Diagnostic (OBD), Diagnostic mode 3: Check DTC memory.
1
3-pin harness connector
-
Terminals are gold-plated
-
Secured to fuel tank with retainer straps
2
Knock Sensor (KS) 1 -G61-*
-
For cylinder bank 1
-
Contact surfaces between knock sensor and cylinder block must be free of corrosion, dirt and grease
-
Wire to 3-pin harness connector secured to coolant pipe
3
20 Nm
-
Tightening torque affects function of Knock Sensor (KS)
4
Camshaft Position (CMP) Sensor 2 -G163-*
-
Terminals of sensor and connector are gold-plated
-
For intake camshaft, cylinder bank 2
5
Connector
-
3-pin
-
Terminals are gold-plated
6
10 Nm
7
25 Nm
8
Washer
-
Conical
-
Note installed position
9
Face plate
-
For Camshaft Position (CMP) sensor