Touareg V8-4.2L (BHX) (2004)
Checking wiring
-
Connect test box to control module wiring harness , connect test box for wiring test.
-
Check wires between test box and 2-pin connector for open circuit according to wiring diagram.
Terminal 1+socket 17
Terminal 2+socket 50
Wire resistance: max. 1.5 ohms
-
Also check wires for short circuit to each other, to vehicle Ground (GND) and to B+.
Specified value: infinite ohms
-
Erase DTC memory of Engine Control Module (ECM) , Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code.
If no malfunctions are detected in the wires and the resistance values are OK:
-
Replace Motronic Engine Control Module (ECM) (J220).