Touareg V8-4.2L (BHX) (2004)
‹› Friction meter (VAS 6222)
‹› Thrust piece (T10182)
‹› Kukko 17/2 Separating device
‹› Sealing grease (G 052 128 A1)
‹› Loctite (648)
‹› 2 M10 x 25 bolts
Removing
-
If necessary, expand holes in Counter hold (3145) to 10 mm diameter.
-
Remove rear final drive. Refer to --> [ Rear Final Drive ] See: Service and Repair/Removal and Replacement/Rear Final Drive.
-
Set rear final drive on a workbench.
-
Before loosening drive pinion nut, measure friction torque.
-
Note this value. After the seal is replaced, friction torque must be restored to this value.
Use friction meter (VAS 6222).
-
Remove driveshaft flange nut as follows:
-
Secure counter holder (3145) with 2 M10 x 25 bolts to driveshaft flange- arrows -.