Touareg 2 V6-3.6L (BHK) (2008)
Reuse undamaged contact sensors and wires.
Cleaning
CAUTION!
Do not use compressed air on the brake system components, the dust produced is harmful to your health!
-
Clean brake caliper.
Use only appropriate solvents for cleaning brake caliper.
Installing
Before pressing pistons into cylinder using piston resetting tool, brake fluid must be removed from the brake fluid reservoir. Otherwise,
especially if reservoir has been topped off, fluid will overflow and cause damage.
-
Press pistons back.
-
Carefully install brake pad wear indicator wire contact sensor in new brake pads.
-
Insert brake pads into brake caliper.
-
Insert retaining spring - 1 -.
-
Install wire for brake pad wear indicator below tab of retaining spring and in brake caliper housing - arrows -.
-
Press retaining spring down and place pad retaining pin in brake caliper.