Touareg 2 V6-3.6L (BHK) (2008)
Continuation for All
First install camshaft adjuster for intake camshaft as follows
‹› Both camshaft adjusters (identification: "24E" on intake side and "32A" on exhaust side) can only bolted in one position on the camshafts -
arrows - by an alignment pin.
-
Turn the sensor wheel - 1 - on the intake camshaft adjuster clockwise - in direction of arrow - until it stops and hold the adjuster in this position.
‹› If the intake camshaft adjuster is attached to the camshaft, the adjuster must be rotated left accordingly with the chain sprocket and then the
camshaft timing chain must be routed.
-
Place the intake camshaft adjuster with the timing chain in place on the camshaft. Note the following:
‹› The timing chain for the high pressure pump drive train sprocket must not hang through.
‹› It must be easy to mount the camshaft adjuster with the timing chain taut and can then be tighten by hand.
‹› Arrow - 1 - on camshaft adjuster "24E" must align with the right notch - 2 - of control housing. Markings on control housing, refer to --> [
Markings on Control Housing ] See: Cylinder Head Assembly/Testing and Inspection