Touareg 2 V6-3.6L (BHK) (2008)
-
Remove mounting nuts - 1 - and remove housing for tail lamp assembly.
Installing
Install in reverse order of removal, noting the following:
-
Bring housing for tail lamp assembly into correct position to the body by hand, hold firmly and then tighten mounting nuts.
-
Tighten the nuts to the tightening specification --> [ Tail Lamps ] See: Specifications/Tail Lamps.
-
Check gap dimension of tail lamp assembly --> [ Tail Lamp Gap Dimensions ] See: Specifications/Tail Lamp Gap Dimensions.
Rear Lid Tail Lamp Bulb Carrier
Tail Lamps
Rear Lid Tail Lamp Bulb Carrier
Removing
-
Switch off ignition, switch off all electrical consumers and remove ignition key.
-
Open rear lid.
-
Clip service cover - 1 - out of locking mechanisms and pull off cover in - direction of arrow -.
-
Disconnect connector - arrow -.