Touareg 2 V6-3.6L (BHK) (2008)
‹› Always observe also the supplementary notes for repairing wiring harnesses on airbag- and seat belt tensioner systems, fiber optic cables,
CAN-Bus wires, antenna wires and wire cross-sections up to 0.35 mm.
‹› A function test must be performed after every repair. If necessary, check DTC memory, erase and/or bring systems into basic setting.
‹› If possible, do not loosen grounding straps from the body (danger of corrosion).
‹› Not all the wire cross-sections installed in the vehicle are contained in the Wiring Harness Repair Kit (VAS 1978) or Wiring Harness Repair Set
(VAS 1978A). If the required wire cross-section is not present, the next greater cross-section must be used.
‹› Shielded harnesses may not be repaired. If faulty, the entire harness must be replaced.
‹› Heat-resistant wires have been installed in the vehicle at various locations, mainly in the engine compartment. Heat-resistant wires can be
recognized by their somewhat duller and softer insulation. Only heat-resistant wires may be used to repair these wires.
Wire Stripper VAS 1978/3
Wire Stripper VAS 1978/3
Wire Stripper (VAS 1978/3) is used for professional stripping and cutting of wires.
Wire Stripper (VAS 1978/3) is a component of Wiring Harness Repair Kit (VAS 1978) and of Wiring Harness Repair Set (VAS 1978A).
Wire stripper has an adjustable stop in its pliers-jaws which can be set to the desired length of wire insulation to be removed.
Stripping:
-
Set the slideable stop in pliers-jaws to the desired length dimension to be stripped.
-
Insert wire end from front up to stop into jaws of pliers and squeeze the pliers completely.