Touareg 2 V6-3.6L (BHK) (2008)
Specified value: 1.5 ohms Max.
If the specified value was not obtained:
-
Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).
-
Check the wiring connection for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring and voltage supply was OK:
-
Replace the Camshaft Position (CMP) Sensor 2 (G163)28 Description and Operation
-
Erase the DTC memory. Refer to --> [ Diagnostic Mode 04 - Erase DTC Memory ] See: Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/Clearing Diagnostic Trouble Codes
-
Perform a road test to verify repair.
If the DTC does not return:
Repair complete, Generate readiness code. Refer to --> [ Readiness Code ] See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness
Codes.
-
End diagnosis.
If the DTC does return and no malfunction is detected in the wiring and the voltage supply was OK:
-
Replace the Motronic Engine Control Module (ECM) (J623). Refer to --> [ Motronic Engine Control Module, Replacing ] See: Engine Control
Module/Service and Repair/Motronic Engine Control Module, Replacing.
-
Assembly is performed in the reverse of the removal.
-
Install the engine cover with air filter.
Final procedures
After repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to --> [ Diagnostic Mode 03 - Read DTC Memory ] See: Testing and Inspection/Reading and Clearing Diagnostic