Touareg 2 V6-3.6L (BHK) (2008)
‹› Shaft with interrupted tooth pattern - 1 - must be in - a - position.
"a = approximately 60 degrees"
-
If necessary, set the interrupted tooth pattern - 1 - on the shaft of the differential motor to the position shown in the illustration (e.g. using a
screwdriver).
Continuation for All
-
Make sure that the O-ring - 1 - that seals on transfer case makes contact in base of groove at the differential motor.
-
Set differential motor on alignment sleeves - 2 - of transfer case.