volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Climate Control Exhaust Gas Sensor|Description and Operation|Page 614 > < Cabin Temperature Sensor / Switch|Service and Repair
Page 1
background image

Climate Control Exhaust Gas Sensor: Description and Operation

Air Quality Sensor

‹› Air Quality Sensor (G238) is installed  in plenum chamber at front left in direction of travel.

‹› The Sensor For Air Quality (G238) contains  a highly sensitive electronic component which can be damaged if it comes in  direct contact with

solvents, fuels or chemicals.

‹› Do not install a sensor that has been kept, for example, in a tool  box.

‹› Do not store removed sensors in areas where they can come into contact  with solvents, fuels and certain chemical compositions fluids or vapors.

Air Quality Sensor

‹› Sensor for air quality detects pollutants in the ambient air mostly  gasoline and/or diesel fumes.

‹› Climatronic Control Module (J255) evaluates  signal from Air Quality Sensor (G238). The A/C  system is activated depending on the strength and

type of heavily polluted  air.

At an outside temperature greater than approximately + 2° C 36°  F recirculation mode switches on when there is only a slight increase in the  level of
air pollutants.

At an outside temperature between approximately + 2 °C and -5  °C, the system only switches to recirculation mode when there is a strong  increase in
the level of pollutants. The A/C compressor also switches on. 

At an outside temperature less than approximately -5 °C, the system  still only changes to recirculation mode when there is a strong increase in  the
level of pollutants. However, it only switches on for approximately 15  seconds and the A/C compressor does not switch on. If the concentration
drops,  the climate control system switches over to the fresh air mode.

‹› The function "Automatic air recirculation" can be switched  off at any time. If the function is active and a request for "Automatic  air recirculation"

is present the A/C compressor is also switched on  when outside temperatures are smaller than +2°. A/C compressor operation  is not possible with
temperatures lower than approximately -5°.

‹› On vehicles with "automatic recirculation", A/C compressor  can also be switched on up to a temperature of approximately -5° C when 

recirculated air was manually switched on.

‹› To ensure that the A/C does not operate constantly in the recirculating  air mode in areas with a consistently higher pollution, the sensor is

self-adapting  it adjusts its sensitivity to the environmental conditions.

‹› If outside air pollution load remains high for longer period of time,  the sensor starts to adapt itself to the changing environmental condition 

through an adaptation program, learning program, the air recirculation request  in evenly polluted ambient air is therefore generally shorter than 12
minutes.  If a succession of peaks in the polluted air is detected, the air conditioning  system can operate over a longer period of time in
recirculated air mode. 

‹› A certain amount of time is required for repositioning of the air conditioning  system doors. In the event that a sudden increase in pollutants is

encountered  like when driving through a diesel exhaust cloud gaseous pollutants can be  taken in with the fresh air into the passenger
compartment until the door  can be closed. For this reason, a dust and pollen filter is installed with  a charcoal layer. A filter that is saturated with
pollutants is no longer  effective and needs to be replaced.

‹› In order to avoid frequent shifting of the recirculated air/fresh air  door, a slight increase of pollutants in the ambient air will not allow for 

immediate shifting the sensor does not send a request to Climatronic  Control Module (J255). The filtering of the charcoal insert  in the dust and
pollen filter will be sufficient.

‹› In order to avoid frequent shifting of the recirculating air/fresh  air door, the requirement from the sensor for "Automatic air recirculation " mode

remains for at least 25 seconds minimum duration period, even  if the pollutant concentration is so far reduced that recirculating air mode  is no
longer necessary.

‹› If the A/C compressor is shut-off in ECON mode, the maximum duration  of the "Automatic recirculated air mode" is limited to approximately  15

seconds by the Climatronic Control Module (J255) to avoid windows from fogging up.

‹› So that fogged windows are cleared as quickly as possible, the Climatronic Control Module (J255) does not permit  recirculated air operation

during the "Defrost" operating mode. 

‹› After the ignition is switched on, the Sensor For Air Quality  (G238) requires approximately 30 seconds to be operational  warm-up time. During

Climate Control Exhaust Gas Sensor|Description and Operation|Page 614 > < Cabin Temperature Sensor / Switch|Service and Repair