Touareg 2 V6-3.6L (BHK) (2008)
-
Switch the ignition on.
-
Using a Multimeter, Check the Camshaft Position (CMP) Sensor 2 (G163) electrical harness connector terminals 1 to 3 for voltage.
Specified value: about 5.0 V
-
Switch the ignition off.
If the specification was not obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J623). Refer to --> [ Motronic Engine Control Module, Replacing ] See: Powertrain
Management/Computers and Control Systems/Engine Control Module/Service and Repair/Motronic Engine Control Module, Replacing.
-
Using a Multimeter, Check the Camshaft Position (CMP) Sensor 2 (G163) electrical harness connector to the Motronic Engine Control Module
(ECM) electrical harness connector T60 for an open circuit.