Touareg 2 V6-3.6L (BHK) (2008)
-
Switch the ignition off.
If the specification is not obtained:
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J623).
-
Using a Multimeter, check the Throttle Position (TP) Sensor (G79)/Accelerator Pedal Position Sensor 2 (G185) 6-pin electrical harness
connector terminals to the Motronic Engine Control Module (ECM) (J623) electrical connector T94 for an open circuit according to wiring
diagram.