Touareg 2 V6-3.6L (BHK) (2008)
Transmission Temperature Sensor/Switch: Testing and Inspection
Transmission Fluid Temperature Sensor, Checking
Special tools, testers and auxiliary items required
‹› Multimeter
‹› Wiring diagram
Requirements
‹› The Transmission Fluid Temperature Sensor (G93) fuse OK.
‹› The battery voltage must be at least 12.5 Volts.
‹› All electrical consumers must be switched off.
‹› The parking brake must be engaged.
‹› The elector lever must be in the "P" position.
‹› The Ground (GND) connections to transmission must be OK.
Test procedure
-
Perform a preliminary check to verify the customers complaint. Refer to --> [ Preliminary Check ] See: Powertrain Management/Computers and
Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Preliminary Check
Start diagnosis
Procedure
-
Disconnect the Transmission Fluid Temperature Sensor (G93) electrical harness connector - 3 -.
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
Repair any damage found to the electrical harness connector.