volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing front interior and reading light in vehicles with panoramic sunroof > < Removing and installing front interior light and reading light

Up!

Removing and installing front interior light and reading light in vehicles without panoramic sunroof
Removing and installing front interior light and reading light in vehicles without panoramic sunroof
Special tools and workshop equipment required
   
t  Torque wrench -V.A.G 1331-
  W00-0427
t  Removal wedge -VAS 3409-
  Note
When removing and installing components that are in view (switches, covers, trim and so on), mask off areas in which tools (removal wedge -VAS 3409-, screwdriver) are used to lever out those components using commercially available masking tape.
Removing:
–  Switch off ignition and all electrical loads, and pull out ignition key.
  W00-0016
–  Using the removal wedge -VAS 3409- or a suitable screwdriver, carefully lever out the lens -1- at its catches -arrows- and remove it from the front interior light -W1--2-.
  N96-10582
–  Undo and remove screws -1-.
–  Release the locking lugs by pushing them in -direction of arrows- and remove front interior light -W1--2- from roof trim, taking connected wiring lengths into consideration.
  N96-10583
–  Release and pull off connector -1-.
Installing:
Install in the same way but in reverse order of removal. When doing this, note the following:
  N96-10584
–  Tighten screws -1- to 1.5 Nm.
  N96-10583

Removing and installing front interior and reading light in vehicles with panoramic sunroof > < Removing and installing front interior light and reading light