Vanagon F4-1915cc 1.9L (1984)
FIGURE 1 - 1ST GEAR BRAKE PISTON, INSTALLING
-
lubricate with ATF
^
ball valve in piston (arrow 2) must line up with drilling in transmission housing (arrow 1)
FIGURE 2 - APPLY SHELL, INSTALLING
^
a = 97 mm
^
drilling (arrow) must line up with ball valve on 1st gear brake piston
Note
Number of inner and outer splined plates used with this length apply shell is 4 each.
New piston with ball valve and apply shell with drilling may be installed in previous transmissions with following requirements:
^
do not use wavy spring washer
^
only use 4 inner and 4 outer splined plates