Vanagon F4-1915cc 1.9L (Water Cooled) (1983)
Harmonic Balancer - Crankshaft Pulley: Technical Service Bulletins
Triple V-Belt Pulley - Removal & Installation Procedure
Applies To
VANAGON
Waterboxer
Group
13
Subject:
Triple V-belt pulley removing/installing
Part Identifier 1376
Key Points Procedure for triple V-belt pulley
A-059
Number
83-02
July 22, 1983
-
remove cover for exhaust muffler
-
remove bolt from right rubber mount of engine carrier
-
insert tool as shown in illustration
^
pin of tool must fit into smaller hole of pulley
^
when loosening: smaller hole of pulley must be up
^
when tightening: smaller hole of pulley must be down
NOTE
Triple V-belt pullies supplied as spare parts have only TDC mark 0.
-
cut 5 ATDC notch 7.5 mm (0.294 in.) to left of TDC mark