Vanagon F4-1915cc 1.9L (Water Cooled) (1983)
Hall Effect Sensor: Service and Repair
Hall generator, replacing
Note: when replacing Hall generator, use repair kit which consists of the following parts:
Hall generator
Circlips
Washers
Pins
Fig. 1 Aperture rotor, removing/installing
-
To avoid bending rotor when prying off, insert screwdrivers through two opposing slots until they contact circlip
-
Check that aperture rotor turns freely after installation by turning distributor shaft
If aperture rotor is bent, it must be replaced
Aperture rotor identification: