Vanagon 2WD L4-2109cc 2.1L (1986)
Installation is in reverse order, noting the following:
^
check door lock for proper function
Power door lock motor/bracket installation, spare parts only
Replacement rear lids are provided with holes prepunched for pop rivets in the inner sheet metal. Additionally, both mounting holes for fastening power
door lock motor to bracket are provided.
Installing
-
position bracket and fasten with pop rivets
-
from inside of lid drill two 4 mm (.56 in.) holes for lower pop rivets Note
Drill bit must extend at least 65 mm (2.5 in.) out of chuck
-
remove any burrs from holes and touch up with paint
-
install rivets (arrows) from outside with a riveting tool
